Check that the electrical rating shown on the rating plate corresponds with your
household electricity supply.
• Stand-by mode and energy saving mode: Plug in the blender and set the
blender jug on the base unit. The power light and indicator lamp will light up
in red; the blender is now in stand-by mode.
If the blender is left idle for 3 minutes the blender will go into energy saving
mode; the power light will remain lit with a red light, while the indicator lamp
will go out. (From energy saving mode, the unit will go into stand-by mode
when any key is pressed)
• ON/OFF button: This button is the ON/OFF key for the pre-set programs. A
selected pre-set program function will only be activated by pressing the ON/
OFF button. Pressing the ON/OFF button again will stop the unit.
• PULSE button: This is the manual button for PULSE operation.
In stand-by mode, with the speed dial pointing to the OFF position, hold the
PULSE button down and the motor will increase to full speed in PULSE mode,
and the indicator lamp will show a white light. When you release the PULSE
button, the blender will return to Stand-by Mode.
• Speed Settings: This blender has 10 continuously variable speed settings.
In stand-by mode, turn the speed dial clockwise from the OFF position, and
the blender will operate at the corresponding speed. By continuing to turn
the speed dial clockwise, the speed will gradually increase, finally achieving
maximum speed. During operation, the work indicator lamp will turn white. The blender will automatically turn off after 10 minutes. To reset the blender
for the next operation, turn the speed dial back to the OFF position.
• Preset Program Key: To use the preset programs, the blender should first
be in Stand-By Mode, then select and rotate the Speed Dial from the OFF
position to the desired preset program setting and when finished press the
ON/OFF button.
To stop the blender during operation of one of the programs, press the ON/
OFF button to stop the blender. After operation of the preset program, the
blender reverts to stand-by mode.
| Icon | Function | Operation cycle |
 |
Soup | Increases to Speed 7 in 7 sec, then increases to Speed H in 3 sec, and keeps at this speed until finish. Total duration is 8 minutes. Every start-up is soft-start. |
 |
Vegetables | Speed H 30s, stop 2s; Speed 6 10s, stop 2s; Speed H 60s, stop 2s; Speed 6 10s, finish. Total operation is 1m 56s. Every start-up is soft-start. |
|
Smoothie | Soft start to Speed H for 8s, and stop for 2s. Repeats the cycle until the total operation time is 30s. Every start-up is soft-start. |
LID, MEASURING CUP
• Insert the measuring cup in the lid by aligning the two tabs in the slots on the
lid and twisting to lock. Then push the lid onto the blender jug to close it. To
open the lid, pull the flap up.