| Blue light always on | Standby / Normal operation / Wi-Fi is connected |
| Blue light breaths | Charging, power is more than 20% |
| Blue light flashes | Firmware upgradein progress /Restoring factory settings / Connecting to the network |
| Yellow light is always on | WIFI is offline |
| Yellow light breaths | Charging, power is lower than 20% |
| Yellow light flashes | Recharging |
| Red light flashes | Abnormal state |
| On/Off button | Long press for 3s, power on or power off. Short press, start or pause. |
| Recharging button | In operation state, short press, robot pauses cleaning. In pause state, short press start recharging. In charging state, short press to stop recharging. |
Cleaning mode/level selection
You can choose various cleaning modes and water flow rates.
Do Not Disturb mode (DND)
When Do Not Disturb mode is activated, proceeding at breakout point, scheduled cleaning and active voice reporting are unavailable in robot.
Do Not Disturb mode is activated by default during the period from 22:00 to 7:00. Do Not Disturb mode can be deactivated in App.
Cleaning mode without map
When no map is stored, the robot will start cleaning each zone by a square area of 6m×6m. When a map is stored, the robot will start cleaning each room along the route planned automatically and return to base after completion.
Memory map
When memory map is activated in the App, the robot will save and update the map after finishing cleaning task and recharging successfully. After a map is completed successfully, you can split or merge zones or name any room in the App.
Edge Cleaning mode
When choosing edge cleaning mode in the App, the robot will automatically recognize range of the area to clean, and start cleaning along the edges, and return to base automatically after finishing cleaning.
Specified area cleaning mode
When an area to be cleaned is specified in the App, the robot will clean the specified area. Note: During cleaning, the robot may go beyond a defined area, remove any obstacle on the floor within defined area since definition of any area will not ensure safe separation.
Fixed-point cleaning mode
When choosing fixed-point cleaning and have selected a target point in the App, the robot will route cleaning task and start cleaning within a rectangular area of 2m × 2m based on the target position defined in the map in App.
Scheduled cleaning mode
User can schedule a cleaning task in App, and robot will start the cleaning task as scheduled and return to the base upon end of the task. Note: Any scheduled cleaning task will not be executed during the time when Do Not Disturb mode is activated.
Virtual wall/forbidden area
User can define virtual wall/ restricted area in App which the robot will avoid cleaning. Note: Before using this function, you have to store a map in the App. Moving the robot or change of indoor environment may cause the original map lost and any virtual wall/ restricted area unavailable.
Reset/restore system
- By long pressing Reset button for 10 seconds, the machine will clear all network connection information, map information, scheduled task and do-not-disturb information, and customization information, and reset the suction power to the default level.
Note: After resetting/restoring the system, the robot needs to reconnect the APP, and the relevant settings in the APP are removed.