AC2B-12000C Installation

CHOOSE YOUR LOCATION
• If tipped more than 45°, allow the unit to set upright for at least 24 hours before start up.
• Place the unit on a firm, level surface in an area with at least 50cm of free space around it to allow for proper air circulation.
• Do not operate in close proximity to walls, curtains, or other objects that may block air inlet and outlet. Keep the air inlet and outlet free of obstacles.
• Never install the unit where it could be subject to:
– Heat sources such as radiators, heat registers, stoves or other products that produce heat.
– Direct sunlight
– Mechanical vibration or shock
– Excessive dust
– Lack of ventilation, such as a cabinet or bookcase
– Uneven surface

WARNING!
• Install the unit in rooms which exceed 10 m².
• Do not install the unit in a place where inflammable gas may leak.

ATTACH THE EXHAUST HOSE
The air conditioner requires being vented outside so that the exhaust air can escape the room which coming from the appliance contains waste heat and moisture. 

Do not replace or extend exhaust hose which will result in decreased efficiency, even worse shut down the unit due to low backpressure. 

Step 1: Connect the hose connector to one end of the exhaust hose.

Step 2: Connect the windows kit adapter to the other end of the exhaust hose.

Step 3: Extend the adjustable window kit the length of your window. Connect the exhaust hose to the window kit. 
Step 4: Close your window to secure the kit in place. It needs to hold the windows kit firmly in place, secure the window kit with duct tape if required. It is recommended that the gap between the adapter and the sides of the window should be sealed off for maximum efficiency.

Step 5: Attach the hose connector to the exhaust air outlet of unit.

Step 6: Adjusting the length of the flexible exhaust hose, to make sure the distance between the unit and the window will be more than 70cm, height from exhaust hose to the floor will be more than 90cm. And avoid bends in the hose. 
Then place AC near an electrical outlet.

Step 7: Adjust the louver at the air outlet, and then switch on the unit.