CONTROL PANEL AND DISPLAY

| 1 | SWING | Adjust the air flow direction vertically. |
| 2 | MODE | Mode button Press to switch the operation mode between fan, cooling and dehumidifier |
| 3 | UP | Increasing the desired temperature (16°C - 32°C) or timer setting. |
| 4 | POWER | Press to switch the machine on or off |
| 5 | DOWN | Decreasing the desired temperature or timer setting. |
| 6 | SPEED | Press to switch the fan speed between high, medium and low |
| 7 | TIMER | Sets a time for the unit to automatically start or stop. |
| 8 | SLEEP | Press to enter sleep mode. Can only be entered in cooling mode |
| 9 | INDICATORS | LED indicators for fan speed and WIFI. |
| 10 | LED Display | This LED Display the Room Temperature or Time Setting |
| 11 | MODE Indicator | This display the Mode Setting between fan, cooling and dehumidifier |
REMOTE CONTROL

SETTINGS
START-UP AND SHUTDOWN
• Press POWER to turn the unit on.
• Press MODE button to select the desired operation mode.
• Press POWER again to turn off the power.
OPERATION MODE
The unit has four operation modes: Cool, dry, fan, sleep.
COOLING YOUR ROOM
• Select the cool mode to lower the temperature in your room.
• Press MODE button repeatedly until the COOL indicator lights up.
• Press Up/Down button to adjust the temperature which is displayed on the screen. The temperature can be set between 16°C and 32°C.
• Press SPEED button repeatedly until the desired fan speed indicator lights up.
• To control the direction of the air flow horizontally, please adjust the inner louver by hand.
Note: The air conditioner stops if the room temperature is lower than selected temperature.
VENTILATING YOUR ROOM
• Press MODE button repeatedly until the FAN indicator lights up.
• In ventilation mode the room air is circulated, but not cooled.
• Press SPEED button repeatedly to select the fan speed as desired.
DRYING YOUR ROOM
• Press MODE button on the control panel or remote control, the dry indicator lights up. The fan speed is unable to select. User should connect the hose to the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot be selected.
SLEEP MODE
• The sleep button can only be set in cooling mode.
• The machine enters sleep mode, all lights are dimmed at the same time, and the buzzer is disabled in sleep mode:
– 1 hour after sleep mode is turned ON, the set temperature will automatically increase by 1°C, and after another hour, the set temperature will automatically increase by 1°C.
AUTOMATIC DEFROST
At low room temperatures, frost may build up at the evaporator during operation.
The unit will automatically start defrosting and the POWER LED blinking. The defrost control sequence is as follows:
A. When the unit operates in the cooling and drying operation, and the ambient temperature sensor senses the evaporator coil temperature is below -1°C, after the
compressor will stop operating for 10 minutes or the coil temperature up to 7°C, the unit restart to cool operating mode.
B. When the unit operates in the drying operation, once the coil temperature sensor senses the temperature of the evaporator is below 40°C and the differential temperature between coil temperature and room temperature is below 19°C after the compressor operation for 20 minutes, the unit start defrosting for 5 minutes and the power indicator blinking.
TIMER SETTING (1HOUR-24HOURS)
The timer has two ways of operation:
| To turn off (When power on) | -> | Press the Timer key to turn on the timer function | -> | Press Up/Down repeatedly to set the delay OFF time |
| To turn on (When power off) | -> | Press the Timer key to turn on the timer function | -> | Press Up/Down repeatedly to set the delay ON time |
| Cancel | -> |
Press Up/Down repeatedly until the LED shows `00`. Note: by pressing POWER you will also cancel the timer |
OVERLOAD PROTECTION
In the event of a power loss, to protect the compressor there is a 3-minute delay until the compressor restarting.
DRAINAGE
MANUAL DRAINAGE
1. When the machine stops after the water is full, please unplug the power plug.
Notes: Please move the machine carefully, so as not to spill the water in the water pan at the bottom of the body.
2. Place the water container below the side water outlet behind the body.
3. Unplug the water plug, the water will automatically flow into the water container.
Notes:
1. Keep the water plug properly.
2. During drainage, the body can be tilted slightly backwards.
3. If the water container cannot hold all the water, before the water container is full, stuff the water outlet with the water plug as soon as possible to prevent water from flowing to the floor or the carpet.
4. When the water is discharged, stuff the water plug.
Notes: Restart the machine after the water plug and drainage cover are installed, otherwise condensate water of the machine will flow to the floor or the carpet.
SELF- EVAPORATING SYSTEM
The self-evaporating system uses the collected water to cool the condenser coils for better, more efficient performance. There is no need to empty the drainage tank in cooling mode, except in high humidity conditions. In drying mode, the drainage tank needs to be emptied. The condensed water evaporates at the condenser and disappears through the exhaust hose.
For continuous operation or unattended operating in drying mode, please connect the attached drain hose to the unit. Condensed water can automatically run into a bucket or drain.
• Switch off the unit before operating.
• Remove the plug of the water outlet opening and keep it in safe area.
• Securely and properly connect the drain hose. Make sure it is not kinked and clear of obstruction.
• Place the outlet of hose over a drain or bucket and ensure that water can freely flow out of the unit.
• Do not submerge the end of hose into water; otherwise it can cause “Air Lock” in the hose.
TO AVOID WATER SPILLAGE
• As the negative pressure of condensate drain pan is large, tilt the drain hose downward toward the floor. It is appropriate that the degree of inclination should exceed 20 degrees.
• Straighten the hose to avoid a trapping water in the hose.