1. ON/OFF button
2. +/- button
3. Mode button
4. Fan button
5. Timer button
6. Heat – not available
7. Wi-fi button
8. Display
9. Cool mode indicator
10. Dry mode indicator
11. Fan mode indicator
12. Fan speed indicator
USE
• After connecting the air conditioner to the power supply, it will sound a beep.
After that, you can operate the air conditioner by the control panel.
• Under ON status, after each pressing of the button on control panel, the air conditioner will give out a sound. Meanwhile, corresponding indicator on control panel will be bright.
1 ON/OFF button
Pressing this button will turn on or turn off the air conditioner.
2 +/- button
Under cooling or heating mode, press “+” or “-” button to increase or decrease the temperature by 1°C (°F). Set temperature range is 16°C~30°C Under drying or fan mode, this button is invalid.
3 Mode button
Press this button and the mode will circulate according to below sequence:
Cool-> Dry-> Fan-> Heat
• Cool: Under this mode, cooling mode indicator is bright. The display shows set temperature. Temperature setting range is 16-30 degrees Celsius.
• Dry: Under this mode, drying mode indicator is bright.
• Fan: Under this mode, the air conditioner only blow fan. Fan indicator is bright.
• Heat: Not available
4 Fan button
Press this button and the fan speed will circulate as “low speed-medium speed-high speed-auto fan-low speed”
5 Timer button
• Press timer button to enter timer setting mode.
• Under this mode, press “ + “ or “ - “ button to adjust the timer.
• The timer will increase or decrease 0.5 hour by pressing “ + “ or “ - “ within 10 hours.
Exceeding 10 hours, the timer will increase or decrease 1 hour when pressing “+” or “-“. After setting the timer, the display shows the temperature if there’s no operation for 5s. If timer function is started up, the upper indicator will keep the display status. Under timer mode, press timer button again to cancel timer mode.
6 Heat – not available
7 Wi-fi button
• Press “WiFi“ button to turn on WiFi function, “WiFi“ icon will be displayed on the remote controller: Hold “WiFi“ button for 5s to turn off WiFi function and “WiFi“ icon will disappear.
• Under off status, press “MODE” and “WiFi“ buttons simultaneously for 1s, WiFi module will restore factory settings.