1. Controller panel
2. Horizontal louver
3. Vertical louver
4. Castor
5. Wire-fixing hook
6. Plug of power cord
7. Filter
8. Air inlet
9. Joint
10. Heat discharge pipe
11. Rear clip
12. Remote controller hook
USE
To change air direction:
1. Up/Down air flow direction:
– Hold the horizontal louvers and adjust the air flow directions.
– Do not adjust the horizontal louvers to the lowest or the highest position in the COOL or DRY mode with the fan speed set too low for an extended period of time, Condensation may form on the louvers.
2. Left/right air flow direction. Hold the vertical louver and adjust the air flow direction.
Caution:
• Do not adjust the vertical louvers to the extreme left or right in the COOL or DRY mode with the fan speed set too low for an extended period.
Condensation may form on the louvers.
OPERATION TEST
• Press on/off button on the remote controller to start the unit.
• Press mode button to select auto, cooling, drying or fan function, and check if
the unit operates normally.
• If ambient temperature is below 16°C the unit cannot operate in cooling mode.