DUST CUP
|
Disassembly Hold the bottom of the dust cup. Press the release button and carefully pull the dust cup out downward. |
Installation Push the dust cup up with the suction inlet facing outward. |
 |
|
CLEANING
Press the Dust cup release button, and the bottom cover opens. Clean the dust bin with water. Make sure it is completely dry before re-assembling.
FILTER COMPONENTS
|
1. Hold the ribs on both sides and pull upwards to remove the filter components. |
 |
2. Remove the filter sponge, lay it with the white side down and tap it to remove dust. It can also be rinsed with the other parts. |
 |
3. Rise the parts under water |
 |
4. The parts needs to be completely dry before installing the filter components into the dust bin. |
DUST SENSOR
For the dust sensor to function optimally it needs to be cleaned regularly. To clean the dust sensor just use your finger and remove the dust collected on the sensor. The sensor is located inside the tube on two sides. Use your finger or a dry towel to wipe over the sensors.
FLOOR BRUSH
 |
1.Press the button and remove the electric floor brush from the extension tube. |
 |
2.Press and hold the button and turn the end cover upwards. |
 |
3. Pull out the rolling brush and clean it. Do not use water! |