MMA1T-TC15 Use

USE
Insert the power plug. Press any button to switch the machine on.
For a better coffee experience, buy the Wilfa espresso accessories on Wilfa.com.

Filling water tank

You can fill the water tank when it is placed onto the machine. Remove the water tank lid, fill it up to the max mark by using a jug or similar. Do not exceed the MAX-mark.
You could also remove the water tank and fill it directly at the sink. Do not overfill. Slide the water tank slowly back on the machine. When it is correctly placed, firmly push it into place.

Capsule
There are two sorts of capsules you can use with the adapters: Dolce gusto and Nespresso Original.
Choose your desired coffee capsule and place it into the correct adapter.
Lift the lever completely and insert the adapter. Close the lever.
Place a cup under the coffee dispenser.
Press the preferred size button.

Ground coffee

We recommend that you use about 8-10 grams of coffee beans. Grind them to espresso size.
Place the ground coffee into the basket in the adapter.
Use the tamper to push the coffee firmly. It shall not exceed the max line.
Lift the lever completely. Insert the adapter into the coffee machine. Close the lever.
Place a cup under the coffee dispenser.
Press the preferred size button.

Energy saving

After 9 minutes of no activity, the unit goes into energy saving-mode. Press any button to activate the machine.

PROGRAMMING QUANTITY
Set coffee volume

The volume can be adjusted from 25-250ml.

  1. Lift the lever and insert the adapter with the coffee of your choice.
  2. Push and hold button until the desired volume is reached. Release the button.

The chosen amount is stored automatically. When you use it again, the cup size has been memorized.

Restore factory settings

If you want to restore the quantities to factory settings:

  1. Take out the power cord and open the lever.
  2. Press and hold the small cup and medium cup buttons.
  3. Plug in the power cord. There is one beep. Let go of the two buttons.
  4. Close the lever. It will beep two times.
  5. Press and hold all buttons. There will be a long beep. Plug out the power cord.
  6. Plug it back in and press any button to switch the machine on. A button will flash in red.
  7. Make sure there is water in the water tank, that the adapter is empty, and that there is a container under the dispenser.
  8. Press the red button. Let the water flow until the red light turns white.
  9. The machine will start to preheat. The white light will stop flashing and will be ready to brew.