Dust box
- Open the cover, press the dust box lock and take out the dust box
- Dispose the trash in dust box, and clean the box with cleaning brush
- Remove the dust box cover, take the filter screen out, dispose trash and clean the screen.
Note:
- It is recommended to clean the dust box at least once a week. Dry the dust box and filter screen before use (at least 24 hours)
- Do not wash the dust box with water, it can damage electric components.
Vibrating water tank
- As shown in the figure, press the tank fastener down, and draw the tank out horizontally.
- Turn the plastic tank cover, discharge any residual water in it and mount the cover in place.
- As shown in the figure, mount the tank properly.
Side brush
- Turn the robot over and remove the side brush fixing screws.
- Remove and clean the side brush.
- Reinstall the side brush and tighten the screws.
Note: It is recommended to replace the side brush every 3-6 months to ensure the cleaning effect.
Main brush
- Turn the robot over, press and hold the two release buttons to remove the main brush cover.
- Take out the main brush upwards.
- Use the knife on the cleaning brush to cut the entangled hair on the main brush and clean the main brush.
- Put back the main brush and the main brush cover, and press the main brush cover to install it in place.
Note: It is recommended to replace the main brush every 6-12 months to ensure the cleaning effect. 
Brush cleaning method
Use the included cleaning tool.
Cliff sensor
Use a soft dry cloth to clean the cliff sensor every 3 months.
Optical sensor
The robot contains precision optical sensor: Front sensor. Be sure to clean these sensors with soft and dust-free cloth to remove any dirt or dust on them, which, if accumulating heavily, may impair the obstacle avoidance performance of the robot. Note: Do not use chemicals such as detergent or spray to clean the sensor.
