To install the charging station, place it against the wall, and connect the power cord. Make sure there is enough space in front and on the sides of the charger.
To install the auto-empty station. Place the dustbin against the wall and connect the power cord.
Note:
- Do not place the charger in direct sunlight.
- The auto-empty station requires more than 1.5-meter space in front and more than 0.5-meter space on both sides.
- Make sure the power cord is not placed where the robot can drag it.
Power on and charge
Put the robot on the base and align the charging electrodes with charging contact. For daily use, you can start intelligent recharge by short pressing the recharge button.
- Robot can’t start up when it has low power. Please put it on the base to recharge.
- Robot will start up automatically after connecting to the base and can’t be shut down while recharging.
Sweeping mode
Open the cover, insert the dust box and press it down.
Note: Clean the dust box regularly in case of the dirt affecting the cleaning effect.
Mopping mode
- Insert the mop along the slot of the mop holder and stick it on the hook and loop fastener.
- Open the water tank cover, fill the water tank and then fasten the water tank cover.
Note:
- Do not use detergents, disinfectants, solid cleaners or other cleaning products, or inject hot water into the water tank in case of corrosion and damage to the water tank.
- It is forbidden to shower or soak the water tank; The water tank metal pole should be dry before performing a mopping task.
- Push the water tank into the bottom of the robot, and it will make a “click” sound when it is installed in place.
Note:
- When mopping the floor, please set up virtual walls or forbidden zones in the carpet area.
- Before starting sweeping/mopping function, be sure to remove any water accumulated on the floor.