Notes:
• Water bucket must be correctly installed for the dehumidifier to operate.
• Do not remove the bucket while unit is in operation.
• If you want to use drain hose to drain water away, please install the hose according to section ”Drainage method”.
• Each time pressing the effective button on the control panel will give out a ”beep” sound.
• When tuning on the unit, the running indicator is ON. Running indicator is OFF under standby status.
Basic Functions of the Buttons
➊ Running Button
Press this button to turn on/off dehumidifier.
➋ +/- Button
Under free drying mode press these buttons to adjust set humidity. Invalid under other modes.
• Pressing + button will increase humidity while pressing - button will decrease humidity. The display range of humidity is 35%~80%. Each pressing will increase/decrease humidity by 5%.
• Continuous Dehumidify Setting: To set the unit for continuous operation, press the - button until the screen reads CO.
❸ Display
Shows the set % humidity level while setting, then shows the actual room %humidity level.
❹ FILTER Button
Press this button to turn off Filter Cleaning Indicator. (When dehumidifier has been operating for 250 hours, Filter Cleaning Indicator will be lit up to remind user of filter cleaning.)
Other Instructions
1. Alarm Warning
If bucket is full or not locked into place for over 3 min, buzzer will go off for 10s to remind you to empty bucket or put it back into the correct place.
2. Auto Stop
When bucket is full, removed or not placed correctly will automatically stop.
3. Memory Function
If power is lost, all of the control settings are remembered. So when power is restored, the unit will start back up in the settings it was in when power was lost.
4. Bucket full light
This indicates that bucket is full or removed or not placed correctly
DRAINAGE OPTION
Option 1 Emptying Manually
Notes:
• Do not remove the bucket when unit is in operation or has just stopped.
Otherwise it may cause some water to drip on the floor.
• Do not use the hose if using water bucket to collect water. When the hose is connected,
water will be drained out through it instead of into the bucket.
1. Hold the handles on both sides of the water bucket and pull it out following the arrow direction. (Attention: Pull out the bucket carefully in case the water may spill out from the bucket and onto the floor.)
2. Empty the bucket by grasping the handle on the top of bucket with one hand and grasping the bottom of bucket with the other hand
3. Replace bucket in the dehumidifier according to the arrow direction
Option 2 Gravity Drain Hose
1. Remove bucket from the unit as instructed.
2. Thread the drain hose onto the nozzle and make sure it’s securely locked.
3. Replace the bucket. Make sure the drain hose goes through the bucket’s drain hole and is placed downward. Lead the hose to the floor drain and then cover the hole with a lid. Note that drain hose should not be pressed; otherwise water cannot be drained out
Note: When you want to take off the drain hose, prepare a receptacle to collect water from the nozzle.
