Notes:
• Water bucket must be correctly installed tor the dehumidifier to operate.
• Do not remove the bucket while unit is in operation.
• If you want to use drain hose to drain water away, please install the hose according to section ”Drainage method”.
• Each time pressing the effective button on the control panel will give out a ”beep” sound.
• When power is connected, power indicator on the control panel will be on and dehumidifier gives out a ”beep” sound simultaneously.
Basic Functions of the Buttons
➊ POWER Button
Press this button to turn on/off dehumidifier,
➋ FILTER Button
Press this button to turn oft Filter Cleaning Indicator. (When dehumidifier has been operating for 250 hours, Filter Cleaning Indicator will be lit up to remind user of filter cleaning.) The filter should be checked for regular maintenance every two weeks disregarding of use.
❸ +/- Button
Under free drying mode press these buttons to adjust set humidity. Invalid under other modes.
– Pressing + button will increase humidity while pressing - button will decrease humidity. The display range of humidity is 35 %~80 %. Each pressing will increase/decrease humidity by 5 %.
– Continuous Dehumidify Setting: This function can be set by pressing
CONTINUOUS button.
Attention: When selecting CO mode, drain hose has to be installed. Otherwise, unit will stop
– When setting Timer On or Timer Off, press these buttons to adjust time.
For specific details, please refer to Timer Button description below.
– When unit is in operation, holding + and - button simultaneously for 3s can lock buttons. If this function is turned on. Button Locked Indicator will be on and display window shows LC, which will blink for 3 times. Then ambient humidity is displayed again. To turn off this function, hold + and - button simultaneously for 3s and the indicator will be off.
➍ Display
Shows the set % humidity level while setting, then shows the actual room %humidity level.
❺ FAN SPEED Button
Pressing this button can set fan speed circularly as: High, Medium, Low.
Corresponding indicator will be on for ejach fan speed.
❻ TIMER Button
Under ON status, press this button and select 2h timer, 4h timer or 6h timer OFF.
Under OFF status, press this button and select 2h timer, 4h timer, 6h timer ON.
When setting “2h” or “4h” timer ON/timer OFF, the corresponding timer indicator will be on. When setting “6h” timer ON/timer OFF, these two indicators will be on at the same time.
Other Instructions
1. Alarm Warning
If bucket is full or not locked into place for over 3 min, buzzer will go off for 10s to remind you to empty bucket or put it back into the correct place.
2. Auto Stop
When bucket is full, removed or not placed correctly or the humidity is 5 % lower than the set humidity, unit will automatically stop.
3. Memory Function
If power is lost, all of the control settings are remembered. So when power is restored, the unit will start back up in the settings it was in when power was lost.
4. Bucket full light
This indicates that bucket is full or removed or not placed correctly.
5. Clean the Filter On indicator light
When dehumidifier has been operating for 250 hours, filter cleaning indicator will be lit up to remind user of filter cleaning.
6. Low ambient temperatures
Note that the dehumidifying process takes longer at low ambient temperatures.
Users are recommended to increase the room temperature for higher (dehumidifying) efficiency.
DRAINAGE OPTION
Option 1 Emptying Manually
NOTICE:
• Do not remove the bucket when unit is in operation or has just stopped. Otherwise it may cause some water to drip on the floor.
• Do not use the hose if using water bucket to collect water. When the hose is connected,
water will be drained out through it instead of into the bucket.
1. Hold the handles on both sides of the water bucket and pull it out following the arrow direction. (Attention: Pull out the bucket carefully in case the water may spill out from the bucket and onto the floor.)
2. Empty the bucket by grasping the handle on the top of bucket with one hand and grasping the bottom of bucket with the other hand.
3. Replace bucket in the dehumidifier according to the arrow direction.
Option 2 Gravity Drain Hose
1. Hose is not provided, so user shall prepare it in advance.
2. Remove bucket from the unit as instructed. Open the drainage cover and then install the drainage joint on the drainage outlet tightly along the arrow direction.
NOTICE:
The drainage joint is with sealing gasket.
Before installing the drainage joint, reinstall the gasket on the drainage joint if it dropped. Otherwise, there will be water leakage phenomenon.
3. Insert the drainage pipe into the drainage joint.
NOTICE:
Make sure the drain hose goes through the bucket’s drain hole and is placed downward. Lead the hose to the floor drain and then cover the hole with a lid. Note that drain hose should not be pressed, otherwise water cannot be drained out.
When you want to take off the drain hose and drainage joint, prepare a receptacle to collect water from the nozzle
