WSFBS-200B Troubleshooting

Problem Possible causes  Solution
Coffee grinder does not start

Power cord is not plugged in

Bean hopper is not in correct position

Plug into power socket

Rotate the bean hopper properly into locked position
Coffee grinder clogs Using setting 1-4 might clog the burrs

Set grinder to 25 and 
gradually adjust back to 
the wanted setting while 
the motor is running with 
beans in the hopper. This 
will remove clogging of the 
burrs

Depending on type of beans, 
wear and factory calibration 
the machine might clog at 
the finest settings

To find the finest setting 
before clogging: Lower 
setting gradually until the 
burrs clog. If it clogs at 
setting 3 then setting 4 
should be considered as 
finest setting
Coffe grinder grinds to coarse even at finest settings Bean hopper not fully rotated in place If the beans are grinded coarse even on the finer settings the head might not be in place. Try to rotate the bean hopper one more revolution
Its hard to adjust to finer settings Grinded beans might stuck between the burrs Let the motor run while adjusting to a finer setting